When it comes to drywall installation, the first step is to prepare the wall surface. Once the area has been prepared, line up the drywall sheet with the desired location where you intend to hang the drywall. If you need to locate studs later, use a carpenter’s pencil to mark them. If you do not have a drywall square, it’s easy to buy one. Then, you just have to use it to score the lines.
After preparing the area, lay out the drywall sheets. Make sure that the edges are parallel to the framing and the bottom sheet is flush with the wall. Once the drywall sheets have been placed, use drywall nails and a T-square guide to make the cuts. It’s better to cut the hung sheet in sections than to have a large sheet of varying sizes. In addition, you should use the center-out method when using a t-square guide.
A drywall board should be centered on the joist or the farthest framing component. Once you have located the center of the board, mark it with a square. Once you have placed the board on the wall, use a utility knife to cut the drywall panel. It’s best to place a square against the first board’s edge to keep it straight while applying the second one. You can use the top plate as a guide for the drywall installation process.